Struct futures_channel::mpsc::Sender

pub struct Sender<T>(_);

The transmission end of a bounded mpsc channel.

This value is created by the channel function.

Implementations

impl<T> Sender<T>

pub fn try_send(&mut self, msg: T) -> Result<(), TrySendError<T>>

Attempts to send a message on this Sender, returning the message if there was an error.

pub fn start_send(&mut self, msg: T) -> Result<(), SendError>

Send a message on the channel.

This function should only be called after poll_ready has reported that the channel is ready to receive a message.

pub fn poll_ready(
    &mut self,
    cx: &mut Context<'_>
) -> Poll<Result<(), SendError>>

Polls the channel to determine if there is guaranteed capacity to send at least one item without waiting.

Return value

This method returns:

• Poll::Ready(Ok(_)) if there is sufficient capacity;
• Poll::Pending if the channel may not have capacity, in which case the current task is queued to be notified once capacity is available;
• Poll::Ready(Err(SendError)) if the receiver has been dropped.

pub fn is_closed(&self) -> bool

Returns whether this channel is closed without needing a context.

pub fn close_channel(&mut self)

Closes this channel from the sender side, preventing any new messages.

pub fn disconnect(&mut self)

Disconnects this sender from the channel, closing it if there are no more senders left.

pub fn same_receiver(&self, other: &Self) -> bool

Returns whether the senders send to the same receiver.

pub fn is_connected_to(&self, receiver: &Receiver<T>) -> bool

Returns whether the sender send to this receiver.

pub fn hash_receiver<H>(&self, hasher: &mut H) where
    H: Hasher, 

Hashes the receiver into the provided hasher

Trait Implementations

impl<T> Clone for Sender<T>

fn clone(&self) -> Self

Returns a copy of the value.

pub fn clone_from(&mut self, source: &Self)

Performs copy-assignment from source.

impl<T: Debug> Debug for Sender<T>

fn fmt(&self, f: &mut Formatter<'_>) -> Result

Formats the value using the given formatter.

impl<T> Sink<T> for Sender<T>

type Error = SendError

The type of value produced by the sink when an error occurs.

fn poll_ready(
    self: Pin<&mut Self>,
    cx: &mut Context<'_>
) -> Poll<Result<(), Self::Error>>

Attempts to prepare the Sink to receive a value.

fn start_send(self: Pin<&mut Self>, msg: T) -> Result<(), Self::Error>

Begin the process of sending a value to the sink. Each call to this function must be preceded by a successful call to poll_ready which returned Poll::Ready(Ok(())).

fn poll_flush(
    self: Pin<&mut Self>,
    cx: &mut Context<'_>
) -> Poll<Result<(), Self::Error>>

Flush any remaining output from this sink.

fn poll_close(
    self: Pin<&mut Self>,
    _: &mut Context<'_>
) -> Poll<Result<(), Self::Error>>

Flush any remaining output and close this sink, if necessary.